thank you very much for answering. I’ve added two pics of the RGB cable’s PCB (both sides – see links at bottom). Can you figure out from the pics if it contains the 470Ohm resistor you were talking about?
So you think having a sync stripper inside my RGB cable is a bad idea in general? Do I have to solder the wire from sync to the 20th pin in order to run my PCEngine with the OSSC properly? Or should I get a new RGB cable without a build in sync stripper?
Thanks in advance!
|_gat||1 minute||This cookie is installed by Google Universal Analytics to restrain request rate and thus limit the collection of data on high traffic sites.|
|__gads||1 year 24 days||The __gads cookie, set by Google, is stored under DoubleClick domain and tracks the number of times users see an advert, measures the success of the campaign and calculates its revenue. This cookie can only be read from the domain they are set on and will not track any data while browsing through other sites.|
|_ga||2 years||The _ga cookie, installed by Google Analytics, calculates visitor, session and campaign data and also keeps track of site usage for the site's analytics report. The cookie stores information anonymously and assigns a randomly generated number to recognize unique visitors.|
|_gid||1 day||Installed by Google Analytics, _gid cookie stores information on how visitors use a website, while also creating an analytics report of the website's performance. Some of the data that are collected include the number of visitors, their source, and the pages they visit anonymously.|
|IDE||1 year 24 days||Google DoubleClick IDE cookies are used to store information about how the user uses the website to present them with relevant ads and according to the user profile.|
|test_cookie||15 minutes||The test_cookie is set by doubleclick.net and is used to determine if the user's browser supports cookies.|
|wp_woocommerce_session_9cc3598a6315be16da4f85bb374cf6a5||2 days||No description|