Reply To: [SOLVED] No Sync after attempting 1.00 bodge wire on 1.6 hardware

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › [SOLVED] No Sync after attempting 1.00 bodge wire on 1.6 hardware › Reply To: [SOLVED] No Sync after attempting 1.00 bodge wire on 1.6 hardware

August 7, 2025 at 11:46 PM #66767
bobrocks95
Participant

    Going to take another stab at this tomorrow.  Wanted to ask again though, if I remove the wire, do you know where the far pin on U1 connects to test, or is it left floating on the stock PCB?  Same question for the pad on R35, if there’s a way to verify either of those are still in-circuit and good.

     

    Thanks for the help so far marqs.