Reply To: OSSC stays dead when powered up

#12393
LazyEpic
Participant

    I’m having the exact same problem but my oscillator is putting out 27 Mhz on the nose, guessing they might have sent out chips without pre-flashed firmware?

    Guessing that means I have to use the JTAG to flash it?

    EDIT:
    My kit is also from the last batch of DIY kits

    EDIT2:
    Gone over every via for continuity according to trace file, all pins for bridges etc, all the regulators for values as well as output when connected, checked every solder-joint, frequency outputs and can find nothing that seems to be off, it just wont react to anything so guessing it’s missing the firmware which is an issue as I don’t have a JTAG programmer at hand.