No products in the cart.
NewHome › Forums › OSSC & OSSC Pro › OSSC – Discussion and support › Bad audio quality through SCART from Genesis (using headphone out) – OSSC 1.6 › Reply To: Bad audio quality through SCART from Genesis (using headphone out) – OSSC 1.6
Just solder 1k resistor between pin 2 & 4, and pin 6 & 4.
Note that Pin 2 and 6 wired to the tip and ring of the 3.5mm plug, pin 4 is ground.
Ok so we tried that and it didn’t seem to make much difference, sound was still noticeably worse on 1.6 than 1.5 + Audio board.
Perhaps there’s two issues here that we’re running into, hopefully Markus’ fix will finally solve it.
Username or email address *
Lost your password?
Email address *
A password will be sent to your email address.