Reply To: OSSC v1.xx series beta firmware

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › OSSC v1.xx series beta firmware › Reply To: OSSC v1.xx series beta firmware

March 2, 2023 at 7:50 AM #56676
uchristo
Participant

    installed the new build (debug version).
    nios2-terminal gave me this:
    Sync LPF value set to 0x0
    PCM1862 found
    RC data read (54 bytes)
    Profile 0 data read (1916 bytes)
    SetInputMode(00,00)
    Input mode is RGB24
    Output mode is RGB24
    SetupAFE()
    Reg[61] = 00
    Reg[62] = 18
    Reg[63] = 10
    Reg[64] = 0C
    Reg[65] = F0
    Reg[66] = 00
    Reg[67] = 3F
    HDMITX_SetAVIInfoFrame: VIC=2, ColorMode=0, Aspect-Ratio=4:3, ITU709=No, ITC=No, pixelrep=0
    SetAVIInfo():
    CTS: 27000
    ### DIY VIDEO DIGITIZER / SCANCONVERTER INIT OK ###

    RCODE: 0x02e0, 1
    ### SWITCH MODE TO AV1_YPbPr ###
    THS source set to 1
    SOG detected

    totlines: 1381 (cur) / 0 (prev), pcnt_frame: 1048575 (cur) / 0 (prev)
    Sync up

    Lines: 1381 p
    Clocks per line: 759
    Hswidth: 127 Vswidth: 0 Macrovision: 0
    Error: no suitable mode found, defaulting to 240p

    OSSC won’t change inputs after this anymore nor reflects the incoming ir-code with green led.

    Non-Debug build constantly toggles between 764-p and 764-i
    23.01. kHz/ 46kHz / 92kHz and 60.23Hz/120.47Hz
    Non-Debug-Build will allow further input after initial selection of source.

    • This reply was modified 3 years, 1 month ago by uchristo.