Reply To: [SOLVED] No Sync after attempting 1.00 bodge wire on 1.6 hardware
Well here’s something that might actually be helpful- that pin on U1 and the closer pad on R35 appear to be connected to ground. Is that expected or did I maybe hit a via near the pin on U1 or something? I’d assume if you just needed to ground the pin or pad there’d be a much closer connection point for the mod.
EDIT: Duh, open source project with gerbers available. Looks like the U1 pin is normally floating, and then after the bodge wire, should connect to pin 46 on the FPGA, IO_16 if that earlier diagram is right?
Still don’t know how I managed to ground it all- the R35 pad I guess is surrounded by ground plane, maybe I need to check if I scraped some soldermask off and managed to short to it???
