1-Chip SFC – Bypass installed, not working right

NewHome › Forums › Repairs and Upgrades › 1-Chip SFC – Bypass installed, not working right

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • May 3, 2019 at 2:51 PM #26119
    PugHoofGaming
    Participant

      Hi all,

      I have an SNS-CPU-1CHIP-01 Super Famicom system and I finally got hold of one of the VGP RGB bypass boards.

      I followed the fitting instructions, following the points for using bypass board’s CSYNC by closing J3 and removing R9, R10, R11, R12, C46 & Q1. I also removed C44, C45, and C47. I then fitted the board as normal.

      I now get no sync to my OSSC and when I try my CRT I get a rolling image. Can someone help me figure out where I’m going wrong?

      I have a dejitter board to install as well, will installing this fix the issue? Is there anything I need to consider when installing both boards? (I can only see examples using Voultar’s RGB Bypass, not borti one provided by VGP.

      Cheers!

      May 3, 2019 at 8:38 PM #26120
      PugHoofGaming
      Participant

        Don’t worry, I figured out the problem – I hadn’t wired the CS pad to anything. After soldering it to the pin 151 on the S-CPUN (via the hole below R9 on the underside of the board), and testing it works, I installed the dejitter board (connecting pin 151 to CSYNC_i on the dejitter, and the CS pad to CSYNC_o).

        Everything seems to be OK now – Hopefully that helps anyone else who makes a similar mistake!

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.