ARGH, lifted pads on J3 J5 J6

NewHome › Forums › CPS2 digital AV interface › ARGH, lifted pads on J3 J5 J6

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • June 10, 2019 at 7:12 AM #26562
    yuro
    Participant

      Hey Marqs,

      Firstly, love your product! I managed to get everything installed and put together. Did a test and video was awesome… but there was no sound. Re-read your instructions and saw that I had to bridge J3, J5, and J6. At this point I’m having a hard time getting the solder to bridge and I end up lifting all the pads on the left side.

      View post on imgur.com

      I looked at the schematics/blue prints and only saw the bridged pads as the only places were BCKI/BCKO, LRCKI/LRCKO, and SDIN/SDOUT exist.

      Any hope in fixing this Marqs?

      June 10, 2019 at 9:46 AM #26565
      yuro
      Participant

        Used a magnifying glass and tested some pads nearby and found the three pads I needed! It’s not pretty, BUT IT WORKS.

        View post on imgur.com

        June 11, 2019 at 4:58 PM #26583
        marqs
        Participant

          Yeah, that should do the job. It should be easy to bridge those SMD jumpers if you first add a blob of solder on both pads, and then heat both together (without using too high temperature) while adding more solder in between.

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.