Damaged unit (Plugged in 9v by mistake)

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › Damaged unit (Plugged in 9v by mistake)

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • February 23, 2020 at 10:30 PM #35714
    NewYears1978
    Participant

      I was showing my OSSC to a friend and I plugged in a component switch power supply instead which was 9v. The light flashed and it went off and I immediately realized my mistake.

      I see no damage to the board anywhere, there was no smoke but it doesn’t do anything anymore aside from the LCD LED slightly flashing when you first plug in the 5v source.

      Sometimes when I plug it in the lights flash others not…once they flashed more than a moment and could even see the orange lights.

      Also noticed there is a D1 LED that flashes red.

      I tested F1 for continuity and it was at 0 so had continuity and I tested D5 and it was not at 0 – so everything checked out there.

      Anything else I could check or can I send this in for repair?

      March 3, 2020 at 3:35 PM #35960
      BuckoA51
      Keymaster

        Did you get your OSSC from us? Where in the world are you based?

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.