Final Fantasy 10 ps2 through OSSC

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › Final Fantasy 10 ps2 through OSSC

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • July 16, 2021 at 2:38 AM #48378
    echofreeze
    Participant

      Hi guys,

      I’m running a ps2 console to an OSSC with HD retro cable. There are horrible black bars top and bottom of the screen that are specific to FF10. Apparently this is normal due to a bad port from NTSC to PAL, but since I’m using advanced hardware I’m hoping there is a way to make this full screen top to bottom (4:3).

      View post on imgur.com

      July 16, 2021 at 3:23 AM #48379
      Zacabeb
      Participant

        You might be able to reduce V.active to 448 and V.backporch by 64 or so to force the display to interpret the picture differently.

        The display might be less tolerant of doing this with a 50 Hz signal though, and there is no guarantee it will recover the intended aspect ratio. You might need to compensate by adjusting H.samplerate, H.synclen, and H.backporch to get the right aspect ratio, at the cost of sharpness.

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.