Firmware update to 1.09 failing

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › Firmware update to 1.09 failing

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • May 28, 2024 at 4:20 PM #61754
    t.rudolph
    Participant

      Dear community,

       

      I´m a new proud owner of OSSC 1.8 (currently running under firmware 1.07a).

      Today I wanted to update to firmware 1.09.

      I was precisely following the steps presented in the update video.

      I´m using Win32DiskImager – it doesn´t give me an error while writing the ossc_1.09-aud.bin file to the microSD card (using a Kingston 32GB microSD).

      But when selecting the Firmware update option in the OSSD menu, it´s saying “invalid image”.

      Then I formatted the SD card once more and tried it with balenaEtcher. After selecting the ossc_1.09-aud.bin file, it shows the error message “Missing partition table. It looks like this is not a bootable image.”. Anyway I ignored it and continued writing the image to the SD card, but OSSD gives me the same result: “invalid image”.

      To be sure, I downloaded the ossc_1.09-aud.bin once again from the firmware site, and tried all of the above again – with the same results.

      Any thoughts from anyone?

       

      Best regards,

      Tobias

      May 28, 2024 at 5:04 PM #61755
      BuckoA51
      Keymaster

        Is your OSSC from VGP or a third party?

        May 28, 2024 at 5:16 PM #61756
        t.rudolph
        Participant

          Hi,

           

          I´ve ordered OSSC from the official website (https://videogameperfection.com/products/open-source-scan-converter/?sld=retrorgb)

           

          Best regards,

          Tobias

          May 29, 2024 at 7:53 AM #61759
          marqs
          Participant

            Do you have a smaller card to try than 32gb?

            June 11, 2024 at 1:42 PM #61897
            t.rudolph
            Participant

              Hi,

               

              sorry, it took me a while to buy a smaller card.

              That actually solved the problem: I bought a 4GB card and the update to 1.09 worked like a charm. Perhaps worth to write this as a statement into the firmware update procedure since the “usual” cards that everybody has around are getting bigger these days.

               

              Thanks a lot for your support!

              Tobias

            • Author
              Posts
            Viewing 5 posts - 1 through 5 (of 5 total)
            • You must be logged in to reply to this topic.