Firmware upgrade OSSC Pro Failed (-2) ] 0.70 and tried 0.75

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › Firmware upgrade OSSC Pro Failed (-2) ] 0.70 and tried 0.75

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • September 29, 2024 at 4:04 PM #63536
    Pascal ter Horst
    Participant

      Hello, as the title describes I get an Failed (-2).

      What I tried is:
      – format SD as fat32  (1 time as guid and 1 time as mbr)  and put the .bin in the root -> Failed (-2)
      – used Balena etcher and write the .bin (also tried rename to .img) to the SD -> Failed (-2)
      – formatted the SD as Fat23 with SD formatter from Tuxera Inc. and again put .bin in the root and tried Balena etcher. -> Failed (-2)
      – Deleted al partitions on the SD card (terminal osx) created a fat23 partition  and also tried the 2 ways (file in root -> Failed (-2) and Balena -> Failed (-2)

      (one eternity later)

      The Micro Sd card is a 4gig SD. The card works well used it for Amiga, and PC. I did a verify card on OSX, no errors.

      So something is not going well and I hope somebody can give me a hint.  Have a nice Sunday

      Best Pascal.

      September 29, 2024 at 4:14 PM #63537
      BuckoA51
      Keymaster

        you are renaming the file to ossc_pro.bin, correct?

        Do not use etcher to write the SD card that’s only for the classic.

        September 29, 2024 at 4:24 PM #63539
        Pascal ter Horst
        Participant

          @BuckoA51 no, I left the name as it was ossc_pro_0.75.bin and now I am feeling very stupid at the moment 🙂

          September 29, 2024 at 4:28 PM #63541
          Pascal ter Horst
          Participant

            @BuckoA51 Thanks for the help..  updating now.

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.