Help pulled pads on diy audio board

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – DIY & Repair Support › Help pulled pads on diy audio board

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • June 8, 2017 at 3:34 AM #13167
    Frankym2612
    Participant

      Hi I wired up my ossc audio board but pulled the pads on the i2s and sck was wondering if there was a fix for this

      June 18, 2017 at 8:47 AM #13322
      marqs
      Participant

        It’s still possible to complete the connections by lifting relevant IT6613 pins and running kynar wires from audio baord to them. You need to be very careful with that kind of job, though.

        June 28, 2017 at 5:29 PM #13567
        Frankym2612
        Participant

          Thanks for the response! So which pins do I lift? I’m guessing lift the pins that I’m soldering to the board?

          June 29, 2017 at 3:04 AM #13580
          Frankym2612
          Participant

            I fixed it! It was tedious but I got it to work had to pull the pins and solder slivers of magnet wire to the board and pins thanks marqs for the response I love the ossc!

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.