IR LED blinks, but OSSC doesn't respond to remote commands

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › IR LED blinks, but OSSC doesn't respond to remote commands

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • October 13, 2017 at 4:36 PM #15992
    pcbrown
    Participant

      Hello,

      I just received my OSSC and while I love it so far, I didn’t realize how important the remote was. I purchased a programmable remote made by RCA (https://www.amazon.com/dp/B003EYV210/ref=asc_df_B003EYV2105214098/) and set it to auto-cycle through various manufacturer codes, and once the OSSC’s IR-associated LED began to blink, I assumed I had landed on the appropriate programming for the remote. However, I can’t seem to trigger any commands via the remote, despite the LED blinking. For further reference: Every button I press on the remote triggers the LED blink.

      Curious how else I can troubleshoot, or, if the remote is somehow sending signals within the range of the NEC IR profile, but not the appropriate ones.

      Thanks in advance for any advice!

      October 13, 2017 at 5:32 PM #15997
      BuckoA51
      Keymaster

        Have you done the remote control setup procedure on the OSSC itself? http://junkerhq.net/xrgb/index.php?title=OSSC#Remote_control_setup

        October 13, 2017 at 5:39 PM #16000
        pcbrown
        Participant

          Well, I’m embarrassed to have missed that step! It did the trick. Thanks so much!

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.