Issue with Samsung Q60 QLED TV and SNES w/ the ossc.

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › Issue with Samsung Q60 QLED TV and SNES w/ the ossc.

Tagged: , ,

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • July 9, 2021 at 4:12 AM #48260
    drewb583
    Participant

      Hi all, I’m using a Samsung Q60 TV and the snes with the ossc. I’m currently using the FireBrandX profiles and i’ve used other displays with my SNES that work completely fine, but my TV is dropping sync with the ossc (no red light is being shown however.) Is there any reason why this is happening? On my monitor through OBS it seems to be working fine (I have a HDMI splitter that I run to my pc)

      July 9, 2021 at 11:19 AM #48268
      BuckoA51
      Keymaster

        Does your SNES have a dejitter mod?

        July 9, 2021 at 9:35 PM #48279
        drewb583
        Participant

          It doesn’t have a dejitter mod, but i’m just confused because it plays nicely with other displays? Is it a samsung only thing?

          July 13, 2021 at 3:13 PM #48335
          BuckoA51
          Keymaster

            Definitely not a Samsung only thing, I’d say more than 50% of TVs are affected by it.

            I’m hoping to have more dejitter boards in stock within the next few months, shortages allowing.

            October 17, 2021 at 4:15 PM #49782
            Michal Stepien
            Participant

              I have SNES PAL 1CHIP with FFVIMAN mod. I use RGB SCART Cable PAL Luma-Sync. If I install dejitter board, do I have to change cable to the PAL CSYNC version or to NTSC version? Right now I have no problems with my HDTV but I’m going to buy Samsung QLED.

              October 19, 2021 at 10:36 AM #49805
              BuckoA51
              Keymaster

                Dejitter is only needed for NTSC consoles (or PAL consoles running NTSC software via SuperCIC).

              • Author
                Posts
              Viewing 6 posts - 1 through 6 (of 6 total)
              • You must be logged in to reply to this topic.