OSSC Pro screen position with PS2 in Scaler mode

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › OSSC Pro screen position with PS2 in Scaler mode

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • November 4, 2024 at 2:03 PM #63986
    DuxTm
    Participant

      Hi,

      I am using the OSSC Pro as scaler on my PS2 and it works perfectly but have black borders on all sides (screen is about 80% filled). After researching the documentation and forums, I cannot find any information how to stretch the image a little bit more.

      On my GBS-C I could stretch the image so it was almost fullscreen.

      Is there such a posibility? I am using a Samsung 4k monitor.

      Thank you,

      November 4, 2024 at 4:43 PM #63989
      Zacabeb
      Participant

        If you’re using the generic timings, you need to adjust H.active and V.active of the mode currently in use by the OSSC Pro. The mode in use is usually preselected when you go to the advanced timings option, but if not you may have to find out which of the timings it is using. About 0.85x the original H.active value should make the PS2 image fill the screen.

        You may want to disable framelock while making adjustments to reduce screen blackout as the OSSC Pro reestablishes sync with the input.

        November 4, 2024 at 7:44 PM #63993
        DuxTm
        Participant

          Great, with H.active and position options (under Scaler option) I completely filled the screen.

          Yes, I already had framelock disabled since I had screen flickering while using it as a scaler for PS2.

          Thanks!

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.