SNES Super CIC Board

NewHome › Forums › Repairs and Upgrades › SNES Super CIC Board

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • August 1, 2017 at 1:39 AM #14175
    B3n77
    Participant

      Hi

      I’m about to buy the SNES Super CIC Board to install in my PAL 1 Chip. The instalation instructions look quite good but after searching the net for a while I was unable to find a single install pic of this mod. It would be great if people could upload a pic of their install here just so there are a few more resorces avalable for this mod. Always good to check out other peoples handy work as well.

      September 5, 2017 at 10:38 PM #14958
      BuckoA51
      Keymaster

        Yes it would be really good to have more documentation. Here’s a picture of a 1 chip install our technician did recently:-

        https://mega.nz/#!eB5HyIyb!pUMIZSqoFL-EowEDa9IfJfik6evA430QOzQzCKgZZsw

        October 26, 2017 at 11:57 AM #16418
        B3n77
        Participant

          I finally got around to installing this board and everything is working brilliantly. I used kynar wire, I know lots of modders don’t recommend it but I’ve never had any problems and I find it easy to work with. Plus you can pass it through via through holes to avoid messy long wires. I can solder quite well but I don’t understand electronics at all so I’m not sure if feeding wire through a via hole is bad practice or not.

          November 7, 2017 at 9:42 AM #16908
          BuckoA51
          Keymaster

            Nice, thank you!

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)
          • You must be logged in to reply to this topic.