FairyKid64

Forum Replies Created

Viewing 1 post (of 1 total)
  • Author
    Posts
  • in reply to: OSSC v1.xx series beta firmware #62283
    FairyKid64
    Participant

      Hi Marqs.  I successfully performed the mod required for the V1 updates.  However, the heat sync on the U1 chip was actually so big it was covering pin 25.  I ended up removing the heat sync to cleanly solder to the pin, but when I removed it, I actually damaged the original over sized heat sync.  Do you have any suggestions on another heat sync that fits better that I could buy to replace this one?  Also, is any old thermal paste good enough for reattachment?

      Thank you!

    Viewing 1 post (of 1 total)