mcmarty

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • March 7, 2018 at 7:01 PM in reply to: Firmware v0.80 #19894
    mcmarty
    Participant

      Hello again,

      I managed to fix the problem by holding down BTN1 at power on and then re-training the OSSC’s remote commands.

      Perhaps I should have done a tad more research before my panic stations post above!

      Phew, now on to trying to force my monitor (Predator XB27HU1) to display above 3x mode.

      Cheers,

      M

      March 7, 2018 at 1:05 AM in reply to: Firmware v0.80 #19882
      mcmarty
      Participant

        Hi,

        I have just updated to 0.80a and my OSSC has stopped reacting to my remote control commands.

        The green led flashes when a command is sent but the OSSC does nothing.

        The remote is working fine and I have double checked using my Harmony remote to no avail.

        The OSSC is still passing through signals from all inputs and the on board buttons are cycling through the inputs without any problems.

        Has anybody else had a similar problem?

        Is there anyway to rollback the firmware without a remote?

        Any assistance would be gratefully received!

        Oh, first post as well, hello everyone 🙂

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)