MegaSuperSuper

Forum Replies Created

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • October 13, 2020 at 7:03 PM in reply to: Can OSSC switch optimal timing resolutions due to in game changes? #42077
    MegaSuperSuper
    Participant

      It’d be handy if profile could be switched based on *vertical* frequency. Most consoles have slightly different timings, so I’d imagine this would work in most cases.

      Also named profiles would be great!

      January 6, 2019 at 7:19 PM in reply to: SNES 5x jitter when TX mode = HDMI, but DVI ok #24628
      MegaSuperSuper
      Participant

        Thanks for the reply. I’m aware of the SNES/NES sync mod, but as I mentioned in my post my TV does work with my SNES. The only problem is when OSSC TX Mode is set to HDMI. DVI works.

        MegaDrive actually displays perfectly in all modes. It’s not just 50/60Hz switch modded, I installed a dual frequency oscillator too, so it outputs a correct 59.94Hz signal.

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)