Marcelo Ramos

Forum Replies Created

Viewing 4 posts - 1 through 4 (of 4 total)
  • Author
    Posts
  • March 6, 2024 at 1:44 PM in reply to: OSSC v1.xx series beta firmware #60506
    Marcelo Ramos
    Participant

      Pin 25 is actually not grounded. I think the first solder must have touched another part of the board, causing grounding. I redid it and now it’s ok. Thank you very much tsukiko an Morpheus_79 for the answers.

      March 1, 2024 at 5:34 PM in reply to: OSSC v1.xx series beta firmware #60348
      Marcelo Ramos
      Participant

        I purchased OSSC from VGP in 2017. It is version 1.6. The problem is that pin 25 is grounded. This way, nothing happen adding a wire between TVP7002 pin 25.

        One test would be to lift the pin to eliminate grounding, but I’m afraid it could damage the device.

         

        February 28, 2024 at 2:12 AM in reply to: OSSC v1.xx series beta firmware #60312
        Marcelo Ramos
        Participant

          Hi Tsukiko! Thanks for the sugestion.

          I’ll start with checking and I discovered on my board that pin 25 is grounded. Do i need to lift pin 25 to solve the problem? Could it damage the device?

          February 17, 2024 at 11:02 PM in reply to: OSSC v1.xx series beta firmware #60240
          Marcelo Ramos
          Participant

            Hi guys!

            I made a mod and updated my firmware of OSSC from 0.90 to 1.09 and now I have only start screen. I can adjust settings like 6x and HDR. But when I connect any console to the SCART, there’s no image, only the message NO SYNC. tried firmwares from 1.01 to 1.08. It didn’t work. Going back to 0.90, everything works fine.

            I’ve checked the mod points and everything seems correct. Can you help me?OSSC MOD

          • Author
            Posts
          Viewing 4 posts - 1 through 4 (of 4 total)