3D Printed OSSC Enclosures .. safe for OSSC ? no problem of overheating ??

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › 3D Printed OSSC Enclosures .. safe for OSSC ? no problem of overheating ??

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 5, 2021 at 11:24 AM #45020
    OliverTwist
    Participant

      Hi !
      Thanks to RetroRGB Weekly Roundup #239, on youtube, I learned about3D Printed OSSC Enclosures.
      Right now, you have two companies which are offering those enclosures :
      Laserbear : https://laserbear.net/shop/ols/products/ossc-case
      and
      retro frog : https://retrofrog.net/products/ossc-replacement-case?variant=38016276299959

      It would be cool to have an enclosure for the OSSC, especially with young teenagers ….
      My concerns are the overheating’s problem.
      Is it safe to place an ossc in a limited enclosures like those above ?
      I’m asking this question here, because you are the creator of the OSSC. You must have the knowledge about this problem.
      Right now, I’m worried because you sold the OSSC in an “open” enclosure and not a “plastic box”…

      February 5, 2021 at 11:56 AM #45021
      BuckoA51
      Keymaster

        It’s a good question and something that definitely needs investigation. We’re actually in touch with Retrofrog at the moment. Looking at his design there should be enough ventilation, not so sure about the laser bear one.

        The OSSC produces the most heat in 5x mode so if anyone takes any measurements it should be then.

        February 5, 2021 at 9:56 PM #45030
        OliverTwist
        Participant

          OK !
          Thanks for the reply and the information.
          🙂

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.