AFTER FW Update OSSC PRO does NOT enters standby mode when update is finished

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › AFTER FW Update OSSC PRO does NOT enters standby mode when update is finished

Viewing 2 posts - 1 through 2 (of 2 total)
  • Author
    Posts
  • September 27, 2026 at 9:39 PM #70822
    MarcoFranco_LA
    Participant

      Ok so ONE of my FOUR OSSC Pros has the following “issue”:

      1. AFTER doing a firmware update the units remains OFF the red light is off, remote control will not turn it on…I need to UNPLUG the power supply from the back and plug it back in and then it work just fine..the unit does get updated…its just the post firmware update behavior that’s annoying because it need to be unplugged… I update all my OSSC Pros via SD card

      “The device enters standby mode when update is finished”<<<Per wiki…Not one of the four units I have

      other THREE OSSC pros enter standby mode when update is finished

      October 3, 2026 at 7:22 PM #70864
      marqs
      Participant

        If OLED display and LED turn off, then the update has completed but something goes wrong on the new fw initialization. Has that ever happened after switching to standby mode? It’s hard to nail down the issue if it occurs on one particular unit.

      • Author
        Posts
      Viewing 2 posts - 1 through 2 (of 2 total)
      • You must be logged in to reply to this topic.