OSSC Pro – Recall Last Preset used when powered on

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › OSSC Pro – Recall Last Preset used when powered on

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • February 9, 2026 at 9:19 PM #68591
    J5
    Participant

      Is there a setting currently in the OSSC Pro to have it recall the last Preset when its powered on? I see where I can set the input it will default to, but Every time I turn off and back on my Pro I have to recall a preset to get a usable image for my CRT setup. If it came back on to the last settings it was using (Which I have saved to a preset) it would be really helpful. Is that in there somewhere already and I just havent found it?

       

      Thank you,

      Jon

      February 10, 2026 at 8:43 AM #68594
      Hypetreme
      Participant

        I’d vouch for this feature too.

        February 10, 2026 at 4:27 PM #68618
        J5
        Participant

          I re-read the JunkerHQ document and see that the unit loads Profile or Preset 0 when powered on. I saved a base preset to 0 so it least its close.

          If its easy to have it load the last, that would be a great feature.

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)
        • You must be logged in to reply to this topic.