PC-Engine Troubles [Solved]

NewHome › Forums › OSSC, OSSC Pro and DExx-vd isl › OSSC – Discussion and support › PC-Engine Troubles [Solved]

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • January 29, 2019 at 10:24 AM #25019
    mimylovesjapan
    Participant

      Hello everyone !
      Someone could help me to resolve my compatibility issue with PC-Engine on OSSC ?
      Some informations :
      – OSSC with the last firmware.
      – OSSC working perfectly with all my other game systems.
      – PC-Engine : games on card (tried with R-type) : the PC-engine is starting at 60.05 or 60.01 Hz, then lose signal sometimes. After swaping many times the AV1, AV2, AV3, I can get 59.94Hz, and no problems during the game/
      – PC-Engine CD-Rom : Here is the problem. Lot of games don’t want to stabilize Hz, they goes automaticly to 60.05 or 60.01 during the game, then lot of signal loose… I don’t know what to do.
      -I use a PC engine modified in Japan by this store : https://page.auctions.yahoo.co.jp/jp/auction/d337601049
      The site says this is a RGB, C-SYNC modification.
      RGB cable was furnished with. It’s a japanese.
      I wait for your help !

      January 29, 2019 at 10:30 AM #25021
      BuckoA51
      Keymaster

        Quality of PC Engine RGB mods varies a lot unfortunately. It’s probably due to poor/outdated mod work, I had similar issues on PC Engines (on XRGB’s too) that were all fixed by just updating the mod.

        January 29, 2019 at 10:38 AM #25022
        mimylovesjapan
        Participant

          Where should I start ? Opening the PC engine ? Or should I try a new cable first ? Or some settings on OSSC ?

          February 12, 2019 at 5:56 PM #25186
          Anonymous

            Open the PC engine. Take a picture of the mod, making sure that component labels are legible. Post a link to the picture(s). We can tell you if the mod is outdated and/or shoddy mod work is to blame.

            February 13, 2019 at 12:26 AM #25190
            mimylovesjapan
            Participant

              Dear NoAffinity,
              Thank you very much for your response.
              I opened a topic here about my problem :
              https://shmups.system11.org/viewtopic.php?f=6&t=64016
              You can find the pictures. They recommanded me to get a DuoRGB-X.

              April 9, 2019 at 5:20 AM #25793
              mimylovesjapan
              Participant

                OK ! Problem solved by increasing Sync tolerance on OSSC board !
                Thank you everyone !

              • Author
                Posts
              Viewing 6 posts - 1 through 6 (of 6 total)
              • You must be logged in to reply to this topic.