RetroTink Mini Passthrough to Component into OSSC no signal

NewHome › Forums › RetroTink Products › RetroTink Mini Passthrough to Component into OSSC no signal

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • January 15, 2021 at 8:34 AM #44466
    TyMiles2012
    Participant

    Not sure if this is more of an OSSC issue or RetroTink issue so I’ll post here. I recently found out that the Mini now has passthrough support. I decided I wanted to be able to multiply my NES into my OSSC at 4X for recording and be able to play on my Trinitron TV, but when I passthrough the signal using the HDMI to powered component transcoder method, my OSSC says no signal, but it works perfectly fine on my TV. Other 240p consoles work, and the RetroTink’s 480p works fine as well, it’s just the mini’s 240p passthrough that isn’t detected by my OSSC. I’ve also tried connecting the transcoder directly into the OSSC to no avail.

    January 18, 2021 at 7:05 PM #44534
    PanderBeah
    Participant

    I’m having a similar problem. Using an mini > hdmi to component > ossc. When the mini is in pass through mode there no signal. I’d like to use pass through because ossc gives a better picture.

    February 7, 2021 at 8:54 PM #45084
    BuckoA51
    Keymaster

    Are you sure your transcoder supports 240p? Not all do.

  • Author
    Posts
Viewing 3 posts - 1 through 3 (of 3 total)
  • You must be logged in to reply to this topic.