Braca862

Forum Replies Created

Viewing 7 posts - 1 through 7 (of 7 total)
  • Author
    Posts
  • March 12, 2018 at 8:24 AM in reply to: Firmware v0.80 #20004
    Braca862
    Participant

      I think the firmware update made the issue with the SNES even worse. The display now flickers constantly, making the SNES unplayable on my TV.

      January 5, 2018 at 3:30 AM in reply to: OSSC Issues on SNES #18353
      Braca862
      Participant

        The SCART cable for the SNES is CSYNC.

        November 9, 2017 at 7:25 AM in reply to: Need Help With OSSC (first time setup) #16978
        Braca862
        Participant

          Now that the audio issues have been taken care of, I got a couple of other questions:

          -How do I decrease the audio delay of the sync drop to 480i when the PS1 is booting up? This is one of the reasons why I switched from the frameister, since with the framemeister, the SCE logo appears just a second before the playstation logo.

          -How can I get the best possible quality on my consoles with the OSSC? Are there any settings such as brightness, saturation, and sharpness?

          November 8, 2017 at 8:37 PM in reply to: Need Help With OSSC (first time setup) #16966
          Braca862
          Participant

            Success! I was able to get it to work!. Turns out, I needed one one of those A/V to 3.5mm cables in order to connect the audio with the “A1 OUT/A2 IN” port. Luckily I had one spare. Now I need to see if I have another one to connect the audio for the dreamcast.

            November 8, 2017 at 6:34 PM in reply to: Need Help With OSSC (first time setup) #16964
            Braca862
            Participant

              I am still getting no sound on the PS2 (and Gamecube) via component nor Dreamcast via VGA. How does the component setup actually work?

              November 8, 2017 at 5:57 PM in reply to: Need Help With OSSC (first time setup) #16962
              Braca862
              Participant

                @megari, you’re right. I checked the bin file and it only said 0.79, no a. =/. It works now.

                EDIT: Looks like after setting Line 5x mode to 256×240 optmi., it appears that the image is stable.

                November 8, 2017 at 5:35 PM in reply to: Need Help With OSSC (first time setup) #16960
                Braca862
                Participant

                  I turned off ‘Allow TVP HPLL2x’ and played around between generic and optimized modes. The screen still flickers, but now occurs between every 30 and 50 seconds.

                  Also, I updated the firmware and I noticed there is no audio settings. There is no sound in any outputs.

                • Author
                  Posts
                Viewing 7 posts - 1 through 7 (of 7 total)