Richard N

Forum Replies Created

Viewing 6 posts - 1 through 6 (of 6 total)
  • Author
    Posts
  • July 29, 2024 at 7:44 AM in reply to: OSSC Pro bug reports #62656
    Richard N
    Participant

      Thanks @marqs. Happy to test it if you have a demo version at some point.

      July 27, 2024 at 1:33 PM in reply to: OSSC Pro bug reports #62623
      Richard N
      Participant

        Thanks for the tip. It’ll certainly be easier than turning it on/off again!

         


        @marqs        : Would it be possible to add an option called “No Audio Fix” that automatically changes Quad Stereo from “off” to “on” to “off” (or vice versa if it’s set to “on”) every time the OSSC Pro is powered on and/or an input is changed? It might be a quick, clean solution.

        July 14, 2024 at 9:04 PM in reply to: OSSC Pro bug reports #62436
        Richard N
        Participant

          Thanks Marqs. I’ll keep trying it and will come back to you. Hopefully, it’s not a defective unit.

          July 14, 2024 at 3:59 PM in reply to: OSSC Pro bug reports #62430
          Richard N
          Participant

            Hi Marqs, hope you’re keeping well. Just to check, is there any solution for my problem (reply #61656)? To recap, I sometimes get a picture without sound and the only way to resolve it is to turn the Pro off and on again.  The problem occurs when I turn the Pro on and it cannot be resolved by changing the inputs.  I’ve tested the audio in 3 ways: (i) via SCART on AV1, (ii) via Component on AV2, and (iii) via SPDIF routed to AV2.  Same issue exists in all cases. I’ve tested it with my Samsung NU7470 TV (specs here); I’ve no other TV to test it with. Could the problem be caused by using the HDMI ARC port?

            May 20, 2024 at 11:18 AM in reply to: OSSC Pro bug reports #61689
            Richard N
            Participant

              Hi, it’s a Samsung NU7470 (here is its specs page in case it helps).  Unfortunately, I don’t have another TV with which to test the Pro.  The Pro is hooked up to the same HDMI port that’s also usable for ARC.  I don’t have any ARC receivers connected, but could it cause a problem?

              May 17, 2024 at 8:36 AM in reply to: OSSC Pro bug reports #61656
              Richard N
              Participant

                Hi, I’d like to add another issue to the Pro.

                • Pro Firmware Version: 0.75
                • Pro Setup: AV1 is connected to a PS1 via RGB SCART.  AV2 is connected to a PS2 via Component.  AV3 and AV4 are currently not connected to anything.  SPDIF is connected to the PS2 with its audio routed to AV2.
                • Problem Category: Audio
                • Problem Description: I sometimes get a picture without sound and the only way to resolve it is to turn the Pro off and on again.  The problem occurs when I turn the Pro on and it cannot be resolved by changing the inputs.  I’ve tested the audio in 3 ways: (i) via SCART on AV1, (ii) via Component on AV2, and (iii) via SPDIF routed to AV2.  Same issue exists in all cases.
                • Request: Has anyone else experienced it too and is there an alternative setting / fix available?
              • Author
                Posts
              Viewing 6 posts - 1 through 6 (of 6 total)