twistedsymphony

Forum Replies Created

Viewing 5 posts - 1 through 5 (of 5 total)
  • Author
    Posts
  • July 18, 2019 at 3:14 AM in reply to: How do I reprogram my Remote? #27048
    twistedsymphony
    Participant

      damn, I was hoping there was a pre-programmed device ID that the remote was set to. Thanks for the great info though. having the raw codes is useful. I’ll have to see if I can run them through my Android phone to program my remote with the original codes since it has an IR transmitter.

      Thanks!

      July 17, 2019 at 7:58 PM in reply to: How do I reprogram my Remote? #27045
      twistedsymphony
      Participant

        Thanks marqs. Do you know if there is a way to reprogram it without another working remote? My friend lives out of state and it might be a few months until I have the opportunity to use his remote to reprogram mine. I’ll have have to ask around and see if I can find another local OSSC owner.

        July 17, 2019 at 7:29 PM in reply to: How do I reprogram my Remote? #27042
        twistedsymphony
        Participant

          If you hold BTN1 while booting the OSSC, and it asks you to press a button on the remote, and it doesn’t work

          That’s exactly what I’ve tried and it doesn’t work.

          then either your remote is at fault or the OSSC IR sensor is.

          As I said in the first post. I had a friend visit with his OSSC remote and it was able to work on my OSSC, so we’ve confirmed that the OSSC IR Sesnsor is good.

          Hence why I created this thread asking how I can properly re-program the remote.

          July 17, 2019 at 2:49 PM in reply to: How do I reprogram my Remote? #27034
          twistedsymphony
          Participant

            the very first step: “To configure the OSSC for a new infrared remote, find a suitable manufacturer code (e.g. from Toshiba, NEC etc.) so that the OSSC’s green LED blinks when a remote button is pressed”

            As I said in my first post: this isn’t happening with my remote. I guess I’m trying to figure out how to set the remote to a “suitable manufacturer code”.

            I did find some generic instructions for the chunghop l336 s but trying to use NEC and Toshiba codes listed in those instructions didn’t have any effect.

            July 17, 2019 at 1:29 AM in reply to: How do I reprogram my Remote? #27032
            twistedsymphony
            Participant

              I did see that page before in my searching, but that seems to be instructions on how to reprogram the OSSC to accept a different remote, not to how program the remote with the default OSSC codes, unless I’m miss-reading it?

            • Author
              Posts
            Viewing 5 posts - 1 through 5 (of 5 total)