alan242

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • April 4, 2018 at 11:32 PM in reply to: GGLabs CGA2RGB – Black Screen #20600
    alan242
    Participant

      It has been a month or two since I did this, but I don’t recall doing anything special on the OSSC.
      I have this setup:

      A CGA2RGB rev B01 and a OSSC is 1.6 with firmware 0.78.

      C-128 RGBI -> CGA2RGB -> VGA OSSC -> HDMI out to a DELL 2407WFP

      I have the jumper set to pins 2-3 (closest to the board edge).
      That will set the CGA2RGB to output separate sync RGBHV.

      I direct plugged the 128 to the CGA2RGB.
      I ran a VGA cable from that to the OSSC.
      The monitor is connected to the OSSC with a HDMI cable with a DVI-D adapter on the monitor.

      From what I recall, the OSSC autosensed the RGBHV signal and worked out of the box.
      I don’t think I set Line2x or 3x.

      Is there a 5V power supply properly connected to the CGA2RGB?

      If none of that helps, let me know and I’ll set it up again and list out any other settings.

      September 26, 2017 at 5:39 AM in reply to: Official "Where's my OSSC 1.6?" thread #15412
      alan242
      Participant

        I received mine in Arizona today. Works great so far. It was very easy to setup with an old Toshiba DVD remote. I currently have a Jaguar hooked up to it.

        I need to practice more with Tempest

        September 22, 2017 at 10:07 PM in reply to: Official "Where's my OSSC 1.6?" thread #15290
        alan242
        Participant

          I am in the Western US. My tracking shows that Royal Mail got the parcel on 9/18. The later tracking said it was sent to LA on the 19th and it arrived in LA on the 21st. USPS tracking says it processed through USPS in LA in the wee hours of the 21st. But no updates since. grumble, grumble, USPS, grumble…

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)