fwaggle

Forum Replies Created

Viewing 3 posts - 1 through 3 (of 3 total)
  • Author
    Posts
  • July 9, 2020 at 2:19 AM in reply to: Remote not working after firmware update #39660
    fwaggle
    Participant

      I’m going to grave-dig here because it’s the first hit on Google/DDG for this exact problem, as it’s been so long since I updated firmware that this tripped me up *again*, and I screwed it up in exactly the same way twice.

      Specifically, with the link above, I have a Harmony remote so I went through that whole ordeal (including Logitech’s terrible software) unnecessarily when this is the only bit you care about:

      Now, power cycle the OSSC while holding BTN1 on the OSSC’s PCB. A target function name (e.g. “MENU”) will then be displayed on the OSCC’s LCD screen. Press the corresponding key on the remote control, if the OSSC receives the code correctly you will be prompted to confirm the new code. Press the same key again to confirm, or BTN0 on the OSSC’s PCB to go to the previous key. If you press BTN0 when configuring the first key, the default keymaps will be loaded.

      Once all remote control keys/buttons are programmed, the new keymap will be saved and the OSSC will return to normal operation.

      That is, updating the firmware wipes the settings, which includes the keymap for the remote, you just have to reconfigure them again and you’re good to go. Don’t panic!

      April 22, 2018 at 9:39 PM in reply to: OSSC 1.5 + Audio board – audio clips on Asus monitor #21043
      fwaggle
      Participant

        Ahh crap, I didn’t even think about that for audio, just assumed it’s fine because the video has always worked flawlessly on it, but you’re 100% right here. I plugged a PSX into it and the audio is fine, that’s a huge relief!

        April 22, 2018 at 5:34 AM in reply to: TV compatibility report thread #21030
        fwaggle
        Participant

          I’m somewhat a connoisseur of cheap TVs it seems:

          Bauhn ATV58UHDC (the 58″ Aldi 4k special with a bundled Chromecast in Australia)

          SNES (NTSC+PAL) works with all modes. Line5x is sharpest, but severely crops the picture, so I use Line4x and force the TV to 4:3 aspect for what I think is the best picture. Audio works fine, including 96KHz sample rate.

          NTSC SNES, PAL PS1 (modded) playing PAL+NTSC games, everything works great, absolutely beyond stoked. Haven’t tested my PAL SNES yet because I lack the correct SCART cable for it.

          Hi-Sense HL32K26PL

          SNES (NTSC) with line-triple seems to work fine, not happy with any of the higher modes though. Only works on DVI mode, HDMI results in no signal (even on the test pattern), though I didn’t play with it much maybe it’s possible to get it to sync. Obviously no audio in DVI mode.

        • Author
          Posts
        Viewing 3 posts - 1 through 3 (of 3 total)