[owlnonymous]

I upgraded to 1.11a tonight on one of my OSSCs. I am getting a lot of capture drops and audio pops.

My other OSSC running 1.10a doesn’t seem to be dropping the capture or having audio pops.

[owlnonymous]

Can you share a JSON file or preferably a BIN file? I’m a noob when it comes to github.

• This reply was modified 1 year, 9 months ago by owlnonymous.

[owlnonymous]

I updated both my official and unofficial OSSCs today. The unofficial OSSC was gifted to me for my arcade setup. I confirmed that the unofficial OSSC had a chip at U10 that was of the same family. I used a lot smaller wire on the second install, which made the installation a lot easier. It also helps if you solder the wire to the correct chip ;). Thank you for continuing to update the firmware for the OSSC. I work with a lot of funky arcade boards and improved sync handling is appreciated.

[owlnonymous]

I had an issue updating from 0.78a to 0.80a on a 1.6. Install went fine, but only 2X works. When changing to all the other modes, it doesn’t switch over. I downgraded back to 0.78 and everything is working again. Any thoughts?

[owlnonymous]

My main capture for the OSSC is a Datapath E1S which works with anything that you throw at it.

For my laptop capture I was using a Avermedia LGX previously with a framemeister, which worked well at 720p, but when I switched over to the OSSC it could only do 2x 480p, and would glitch out every so often.

But I have good news! I picked up an Elgato Cam Link, and I can confirm it works perfect at 2x, 3x, and 4x. It could possibly work with 5x with some further tweaking. http://a.co/b5r21Ob

[Author]

Posts