SCART to VGA adapter for Morph 4K

Use this handy adapter to convert a D-Sub 15 (VGA) input on a Morph 4K Analogue Bridge into a SCART input. Using this adapter you could convert the Dual VGA bridge into a VGA and SCART bridge, for example.

Comes with both the SCART adapter and 2 x 1.27mm jumpers.

Compatible with Morph 4K + Analogue Bridge only. Not compatible with OSSC or RetroTINK products. A similar adapter for OSSC Pro is available here.

Installation instructions

The adapter is plug and play, however if you wish to route audio through the SCART socket, you must install the two supplied jumpers to the bridge board back plate.

1) Follow steps one and two of this tutorial to open the Morph 4Ks case.

2) Locate the jumper points. The picture below shows an example of the dual VGA connector with the correct location circled. Looking down directly at the connector with the ports facing away from you, the jumpers are installed vertically (from top to bottom) over the two sets of pins on the right.

3) Install the jumpers as shown and re-assemble the case. You can now route audio through the SCART adapter and into the Morph 4K.